UESP Forums

When I play daggerfall, I can only open this little dosbox window, is there a way to play in fullscreen?

If you used DaggerfallSetup to install your Daggerfall copy, try the following.

Open up the DosBox.conf file in your /Bethesda/Daggerfall directory with a text editor (notepad will do, Programs->Accessories->Notepad on XP).

Scroll down to

fullscreen=(Whatever it says here)

and replace it with

fullscreen=true

And also

fullresolution=(Whatever it says here)

and replace it with

fullresolution=1366x768 (or whatever your desktop screen resolution is)

Just below there you will see, and for improved graphics should change

output=(Again, whatever it says here)

replace that with

output=opengl (this may vary based on your video card but I think most support OpenGL these days)

While you're at it, scroll further down and you will see

scaler=(Whatever it says here)

and replace it with

scaler=3xsai

This is the setting that will make the game look much better and allow you to fullscreen in widescreen (as opposed to the 2xsai usually recommended) with this improved filter.

And as mars mentioned, with DosBox you can always just hit Alt and Enter at the same time to switch between fullscreen and 320x200