Page 1 of 1
completequest <questid>
Posted: Thu Jul 29, 2010 7:26 pm
by Momoiro
Well, as sake of the Roleplay I need to complete some quests with the console. But I need to do this:
completequest <questid>
What to put in questid? Where to find it? I want to complete the current quests...
Re: completequest <questid>
Posted: Thu Jul 29, 2010 7:37 pm
by Veck
The wiki is your friend.
Look at the info just before the brief description of the quest. One of the lines will say ID, followed by four digits eg. ID:MQ01. Those four digits are the ones you want.
Re: completequest <questid>
Posted: Thu Jul 29, 2010 8:04 pm
by Momoiro
I type this:
completequest MG04 but it doesn't work
Re: completequest <questid>
Posted: Thu Jul 29, 2010 8:11 pm
by Veck
I'm afraid I don't know enough about console commands to help you any further. But there's plenty of people here who know what they're doing, so if you wait around I'm sure you'll get an answer

Re: completequest <questid>
Posted: Thu Jul 29, 2010 8:15 pm
by Momoiro
I hope so.
Re: completequest <questid>
Posted: Thu Jul 29, 2010 11:23 pm
by KrisCrash
Isn't it "setstage" and then the relevant stage? Stg. 100 is a typical "quest done" stage.
Re: completequest <questid>
Posted: Fri Jul 30, 2010 1:05 am
by Elune
Make sure you have the quest you want to complete selected in your journal.
Re: completequest <questid>
Posted: Fri Jul 30, 2010 8:24 am
by Momoiro
The stage thing worked! Thanks a lot
