UESP Forums

The first thing we should do is to install the game from within DOSBox. So start DOSBox and write the following: If you downloaded the free Daggerfall, then just mount the unpacked DFCD folder as D instead of the second line. For example; (C:\DFCD varies depending on where you unpack the dfinstall.zip file)

Now the installation should begin. Skip the sound settings in the beginning and go straight to the install. The default size is minimum, but change that to huge. Install it to the default path of c:\dagger. The installation will be quite slow because of the mere cycles of 3000, so press CTRL+F12 a couple of times to raise it to 8000 or so, or higher if you're sure that your CPU can handle it.

After this, it's time to configure the sound. For digital, select Sound Blaster 16/AWE32, port 220, IRQ 7 and DMA 1. For MIDI, select Sound Blaster 16, port 388 or MPU-401, port 330. MPU-401 is the better choice of the two, and I recommend using it, but may under some special circumstances not work (mainly for non-Windows users). After this the installation should end.

But not all the files were copied, so lets manually copy those. Write the following in DOSBox: After this, leave DOSBox in the background. We will return to it shortly.

Now it's time to download the extra quests and the patch. Unpack the quests into DOSBox folder\Games\DAGGER\ARENA2 and move/copy the dag213.exe file to DOSBox folder\Games\DAGGER.

As it is now, some of the files in the ARENA2 folder are writeprotected, and the patch doesn't like that, so we have to change that. Go into DOSBox folder\Games\DAGGER\ARENA2 and select all files, choose properties and make sure that "Read-only" is not checked, and then press ok, and you will change the writeprotection on all files.

Now go back to DOSBox and type the following: The patch will start to install itself. Answer yes on all the questions. After the patch installation is done, you can exit DOSBox. It's time to do some editing with notepad.

Open Z.CFG in DOSBox folder\Games\DAGGER and make sure that both PATH and PATHCD say c:\dagger\arena2\ and then save the file. (you won't need the CD anymore).

Now open the dosbox.conf file which is where you installed DOSBox and do the following changes:
memsize=16 should be changed to 40. The game uses about 32-34 or so, but it's good to have a safety margin.
core=auto should be work just fine as the dynamic core is rather mature now. However, if you run with the dynamic core on a fast computer you should limit the amount of cycles cause I've seen the jitterbug otherwise. If you stumble upon any problem, then go to the normal core.
cycles=max runs just fine. If you want to run at some specific cycles I would recommend about 20000 - 30000. You should cap it there somewhere if you use the auto/dynamic core with cycles=auto limit 30000.

Then go to the bottom where it says "# Lines in this section will be run at startup." and add the following lines: Save the config file as Daggerfall.conf and you're done with that.

If you have problems to get the mouse to work while playing, then press CTRL+F10

Quote over.